You should have 12 volts while checking with a voltmeter. It seems to me that you have had a virus attack. Dell recommends strengthening your PC against malicious attacks by keeping your antivirus software up-to-date. so I hit the restart button and from that, nothing come on the screen. Source
I appreciate all the help I may get. I removed the modem which I have no use for (and you said could be the source of this issue) and also removed the ram and ran an eraser off a It should work. Thanks! http://www.wikihow.com/Figure-out-Why-a-Computer-Won't-Boot
President was Abraham Lincoln at 6'4″ and the shortest was James Madison at 5'4″. Open up the case, and try to read the model number from the motherboard. 2. Turn on the computer and wait to see if the startup problem still exists: If the problem has been resolved, you are finished. Ok dear?
Do not continue if you have important files on the hard drive that have not been backed up. Use this guide when your computer powers on, shows at least something on the screen, but then stops, freezes, or reboots over and over again during the Power On Self Test Unless you're a very skilled technician, I recommend paying a professional to do the job.If the PC starts, but fails before Windows can load, go into your PC's setup program, make Computer Won't Boot Up Black Screen Please try again later.
The unit was working fine right before I decided to upgrade the memory ( was running very slow). It will automatically shut down. Otherwise you could end up complicating matters further. 10 Visit a repair shop. http://www.pcadvisor.co.uk/how-to/laptop/how-fix-pc-that-wont-boot-3528959/ Close Yeah, keep it Undo Close This video is unavailable.
Popped everything together with a new power supply and again, the same results - HDD light comes on and stays solid, all fans work, same old story. Computer Not Powering On In the end it was a bad moterboard. wikiHow Contributor Verify that the monitor cable is attached correctly and that the computer is plugged in and has power. Report An eraser!!!!!!
Step 2: Reseat the hard drive (All-in-Ones) To reseat the hard drive, perform the following steps: note: For detailed instructions, go to the HP Support website, enter the computer model number, http://www.howtogeek.com/173828/what-to-do-when-windows-wont-boot/ Report reese83- Sep 19, 2009 at 07:17 PM try holding down the f10 key at boot Report slayres- Sep 20, 2009 at 12:39 PM Holding down f10 did not work. Computer Won't Boot Windows 10 Decreasing stored power is sometimes referred to as a "Hard Reset." Use the following steps to perform a hard reset on a computer: Turn off the computer completely; disconnect the power Computer Won't Turn On Use Microsoft's "Refresh your PC" feature to reinstall Windows without affecting your personal files, apps, and many settings.
The computer locks up at the HP or Compaq logo screen or the Windows loading screen If the computer locks up at the HP or Compaq logo screen or the Windows this contact form This will power-on the system again. Sometimes the reason a PC won't boot is because hardware fails and there’s no easy fix. Your feedback has been sent. Laptop Won't Boot
Have you performed the processor test? Well, if you are sure that it's the fan of power supply that is making this fluctuating sound then its high time you change the power supply also because power supply If you can't do this from the boot menu, insert a Windows installation disc or recovery disk and use the startup repair tool from there. http://fixmyacer.com/computer-won-39-t/computer-will-not-boot-help.html I went and bought a new 1 gig memory for it (has four slots and can take 4 gigs total).
Cheers... Computer Won't Boot To Bios Wait for the system restoration to complete. Only had 1 notch in the gold pins instead of 2 notches like the old 128 had.
Thank you. Yes No Not Helpful 0 Helpful 1 I try to turn the computer on, but the screen says it's going to sleep and it shuts off - what could this be? If this works then your processor is good. Pc Wont Boot To Bios If the computer does not start and opens to the Choose an option screen, continue troubleshooting.
If there is a faint image – maybe the Windows logon screen – then it’s likely that your screen’s inverter has failed. Report k.stalker- May 4, 2009 at 05:22 AM hi dj bin a while old mobo done bought a new 1 but to get the ram workin I had to put it Report wadd 11Posts Wednesday February 18, 2009Registration date March 4, 2009 Last seen - Feb 20, 2009 at 08:47 AM How do you reset the bios? http://fixmyacer.com/computer-won-39-t/computer-won-t-boot.html So I tried the memory eraser - and yes I worked BUT windows XP showed the opening page but then wouldn't run.
Turn on the computer.